VMware PACKAGE MANAGER 1.1 Manual de usuario descargar pdf (Pagina 31)

Installing for RHEL 6 or CentOS 6

Figure 3.4. Setup Wizard: Step 2 (Discovery)

2. For each network or IP range in which you want Resource Manager to discover devices, enter an address

or range. For example, you might enter a network address in CIDR notation:

10.175.211.0/24

or as a range of IP addresses:

10.175.211.1-50

3. If you want to enter multiple addresses or ranges, click +. For each network, you must enter a netmask

or IP range.

4. For each network or IP range, specify the Windows, SSH, or SNMP credentials you want Resource Manager

to use on the devices it discovers. You can enter only one of each. Resource Manager attempts to use the

same credentials on each device it discovers within the networks or IP ranges specified.

5. Click Discover.

Resource Manager schedules jobs to discover devices in the networks and IP ranges you specified. (To see

job status, navigate to Advanced > Settings, and then select Jobs in the left panel.)

When discovery completes, a notification message appears in the Messages portlet on the Dashboard.

Note

You can bypass device discovery through the wizard. Click Skip to the dashboard to go directly to

the Resource Manager Dashboard. Later, you can discover devices by following the steps outlined in

Resource Manager Administration.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 68 69

Sin comentarios

VMware PACKAGE MANAGER 1.1 Manual de usuario Pagina 31