
Technical white paper | HP Enterprise Virtual Array Storage and VMware vSphere 4.x and 5.x configuration best practices
63
By default, vSphere 4.x claims all HBAs installed in the system, as shown in the vSphere Client view presented in Figure E-1.
Figure E-1. Storage Adapters view, available under the Configuration tab of vSphere Client
This appendix shows how to assign HBA3 to VM2 in vSphere 4.x.
EVA configuration
This example uses four ports on an EVA8100 array (Ports 1 and 2 on each controller). A single EVA disk group was created.
The EVA configuration is summarized in Table E-2.
Table E-2. EVA array configuration summary
Default disk group, with 13 physical disks
\VMDirectPath\ESX-VMFS-LUN1: 50GB
\VMDirectPath\ESX-VMFS-LUN1: 50GB
\VMDirectPath\ESX-VM-RDM-Win2k8: 40GB
ESX LUN 3
WIN VM:
disk1 (RDM)
\VM-DirectLUNs\Win2k8-VM-dLUN1: 30GB
\VM-DirectLUNs\Win2k8-VM-dLUN2: 30GB
Port 1: 5006-0B00-0063-A7B4
Port 2: 5006-0B00-0063-A7B6
\VMDirectPath\ESX-VMFS-LUN1: 50GB
\VMDirectPath\ESX-VMFS-LUN1: 50GB
\VMDirectPath\ESX-VM-RDM-Win2k8: 40GB
\VMDirectPath\ESX-VM-RDM-RHEL5: 40GB
Comentarios a estos manuales