VMware GSX Server 3 Administration Guía de instalación Pagina 318

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 436
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 317
www.vmware.com
326
VMware ESX Server Administration Guide
Setting Your Multipathing Policy for a LUN
You can specify the default policy for the multipathing feature. There are two policies:
fixed — ESX Server always uses the preferred path to the disk; if it cannot access
the disk through the preferred path, then it tries the alternate paths. Fixed is the
default policy for active/active storage devices.
Enter the following command to select the fixed policy for a disk, in this
example, vmhba0:0:0.
# vmkmultipath -s vmhba0:0:0 -p fixed
mru — ESX Server uses the most recent path to the disk until this path becomes
unavailable. That is, ESX Server does not automatically revert back to the
preferred path. Most recent path (mru) is the default policy for active/passive
storage devices.
Enter the following command to select the mru policy for a disk, in this example,
vmhba0:0:0.
# vmkmultipath -s vmhba0:0:0 -p mru
Note: You can select a different policy for each disk.
Specifying Paths
You can use the vmkmultipath command to disable and enable paths, set the
active path, and set the preferred path, as illustrated in the following examples. You
configure paths by setting path modes with the -s option.
Enabling a Path
Use the -e option to enable paths with vmkmultipath. In this example, you are
enabling the path from controller vmhba1:0:1 to disk vmhba0:0:1.
# vmkmultipath -s vmhba0:0:1 -e vmhba1:0:1
Disabling a Path
Use the -d option to disable paths with vmkmultipath. In this example, you are
disabling the path from controller vmhba1:0:1 to disk vmhba0:0:1.
# vmkmultipath -s vmhba0:0:1 -d vmhba1:0:1
Setting the Preferred Path
Use the -r option to specify the preferred path to a disk. In this example, you are
setting as preferred the path from controller vmhba1:0:1 to disk vmhba0:0:1.
# vmkmultipath -s vmhba0:0:1 -r vmhba1:0:1
Vista de pagina 317
1 2 ... 313 314 315 316 317 318 319 320 321 322 323 ... 435 436

Comentarios a estos manuales

Sin comentarios